Setting Series/Parallel Operation Mode - Chroma 62000H Series Operating & Programming Manual

3.3.3.3 Setting Series/Parallel Operation Mode

3.3.3.3.1 Setting SLAVE
CAUTION
When MASTER OR SLAVE sets to SLAVE, it has to set the SLAVE to SLAVE1 ~ SLAVE9
and M/S TERMINATOR selection. Set the SLAVE in sequence starting from SLAVE1.
1. In Config Setup page, press "
display Figure 3-31.
2. Use " ", "
selection column.
3. Use the numeric (
as Figure 3-32 shows.
4. Press " " to confirm and press "
ENTER
5. Use the numeric (
the TERMINATOR as Figure 3-32 shows.
6. Press " " to confirm.
ENTER
7. Press " EXIT " to return to the MAIN PAGE.
It is necessary to set SLAVE first and MASTER last when operating
62000H Series DC Power Supply in series or parallel mode, or it may
not be able to operate due to communication error.
3
" keys to move the cursor to the PARALLEL OR SERIES
1 0
~ ) keys or "Rotary" (
1 0
~
" and " " to select PARALLEL /SERIES and
ENTER
Figure 3-31
) knob to set SLAVE1~SLAVE9
Figure 3-32
" to return to the MAIN PAGE.
EXIT
) key or "Rotary" (
Manual Operation
) knob to ENABLE or DISABLE
3-21