Series/Parallel - Chroma 62000H Series Operating & Programming Manual

Programmable DC Power Supply 62000H Series Operating & Programming Manual
4. Use the numeric kesy (
MODED to ON/OFF and make the pin 10 of ANALOG INTERFACE take the command
from the OUTPUT button on the front panel.
3.3.3

SERIES/PARALLEL

62000H Series DC Power Supplies are able to operate in series or parallel. The voltage is
up to 1200V if connecting in series and the current is up to 3750A if connecting in parallel.
1.
2.
62000H Series
62150H-1000
3.
4.
5.
6.
3-18
Figure 3-26
0 1
~
Series/Parallel cannot be mixed in use.
The maximum output voltage or current is 1200V or 3750A when
operating the 62000H Series in series or parallel. Table 3-1 lists the
examples of 62150H-40, 62150H-450, 62150H-600 and
62150H-1000.
Max.
Model
Devices
62150H-40
62150H-450
62150H-600
Different model is unable to be operated in parallel or serial.
Be sure the breaker capacity is enough and the earth wire is
grounded to earth ground when series/parallel is in use.
When the devices to be paralleled are over 5 sets (>5), please
contact the Service Center or agent of CHROMA.
Please configure the DC Power Supplies up and down stack for
parallel connection. The standard CURRENT SHARING cable is
unable to use if placing the devices lateral for parallel configuration.
It is necessary to purchase another optional CURRENT SHARING
(100CM) cable for use. Please contact CHROMA Service Center or
local agent for further information. Also, be noted that the paralleled
) or "Rotary" (
Table 3-1
Serial
Max. Output
Voltage (V)
2 80
2 900
2 1200
2 1200
) knob to set the DCOUT ON
Parallel
Max. Max. Output
Devices Current (A)
10 3750
10 340
10 250
10 150