Connecting - JLCooper Electronics SloMoPro User Manual

Connecting

Connecting the SloMoPro is straightforward. Connect the large 25 pin D-Sub
connector to the rear of the SloMoPro. Secure the connector the SloMoPro by
screwing the lock screws into the connector. Connect each video device or video
server to the smaller 9 pin D-Sub connectors. Some video servers have more than
one connector, which allow simultaneous control of the recorder and player. In
these cases, connect each port to its own connector on the SloMoPro.
Lastly, connect the SloMoPro to a source of power. This can be either from the
power mains using the provided power supply or directly from 9-12 volts DC. The
connector is a 2.1mm coaxial power connector. The center pin is positive. A power
switch on the rear panel turns the SloMoPro on or off.
SloMoPro RS422 User Manual
7
Deck #1
1/A
Deck #2
2/B
Deck #3
3/C
Deck #4
4/D