Table of Contents
Advertisement
Rewind, F-Fwd
Pressing either of these buttons causes the SloMoPro to send the Rewind or
Fast Forward command. It's action can be latching or momentary. The
default action is latching. This can be configured in the menu.
This illuminates when the video device reports back that it is rewinding.
R-Play
Pressing this button causes the SloMoPro to send a Shuttle Reverse at 1x
command.
There is no P2 status message for Reverse Play so this illuminates after the
SloMoPro sends the Shuttle Reverse command.
Stop
Pressing this button causes the SloMoPro to send the Stop, Still (Shuttle
Forward at 0x) command. It can also be set to send Still on the first button
press and Stop on subsequent button presses. The default action is Still,
Stop. This can be configured in the menu.
This illuminates when the video device reports back that it is stopped.
Play/Rec
Pressing this button causes the SloMoPro to send the Play command.
Alternately, pressing and holding the Shift button while pressing the Play
button will cause the SloMoPro to send the Record command. Refer to the
Record Modes section for more detail.
The Record command can be disabled in the menu. Refer to the
Configuration Menu section for more detail.
This illuminates when the video device reports back that it is playing or
recording.
W1, W2
These are user definable buttons. This can be configured in the menu.
Frame-1, Frame +1
Pressing either of these buttons causes the SloMoPro to move the video
device forward or backwards by one frame. The frame rate must be
configured or the SloMoPro to properly handle the transition around 00 sec.
Jog Wheel
Turning this wheel causes the SloMoPro to send Jog Forward or Jog Reverse
commands to the video device. This can be enabled or disabled by the Jog
button described below.
Shuttle Ring
Turning this ring causes the SloMoPro to send Shuttle Forward or Jog
Reverse commands to the video device. The LEDs above the Shuttle Ring
indicate the shuttle direction. Both LEDs illuminated indicate the the shuttle
speed is 0 (still or pause).
SloMoPro RS422 User Manual
12
Advertisement
Table of Contents
