Cue/Ply/Stop" And "Cueplystp Slo" Specific Operations; Saving A Cue With Start And Stop Times; Playing Back A Cue/Ply/Stop Or Cueplystp Slo Cue - JLCooper Electronics SloMoPro User Manual

"Cue/Ply/Stop" and "CuePlyStp Slo" Specific Operations

Saving a Cue with Start and Stop times

1. Insure that in either Cue/Ply/Stop or CuePlyStp Slo mode.
2. Select a starting Cue number by entering the number on the keypad, then
pressing CLR/ESC. The number will show as the leftmost three digits on the
top line.
3. At desired Start point, press Mark In. An asterisk appears to the right of the
cue number. This may take place with SloMoPro playing at any speed or
stopped.
4. At desired Stop point, press Mark Out. Again, this may take place with
SloMoPro playing at any speed or stopped. The Store Cue LED will light,
and the current time will freeze on the display.
5. If planning to have the automatic SloMo speed captured, you can at this
point move the T-Bar to a desired speed, which will be displayed on the
second line. If the ENABLE LED is off, this may be done without affecting
the playback that may be going on.
6. Press the ENTER key. The Start and Stop times, along with the SloMo speed
will be saved to the currently displayed storage location, then the Cue
number will auto-increment.
7. Repeat steps 3 thru 6. Each time, the Cue number will increment to the next.

Playing back a Cue/Ply/Stop or CuePlyStp Slo Cue

1. Make sure in correct mode.
2. Enter the desired Cue number on the numeric keypad.
3. Press ENTER.
4. Controlled SloMoPro will be directed to cue to the Start time minus any
preroll time. Once there, either a Play or a SloMo command will be issued.
The exact command sent is the one set in the T-Bar Message Menu item.
When the SloMoPro has reached the prestored Stop point, a Stop command
is issued.
SloMoPro RS422 User Manual
29