JLCooper Electronics SloMoPro User Manual page 15

Mark In / Mark Out
Pressing either of these buttons causes the SloMoPro to temporarily store
the current timecode for Instant Replay and Cue/Clip Store functions. Refer
to the Cue Operations section for more detail.
Store Cue
Pressing this button causes the SloMoPro to store the current Mark In and
Mark Out points for Cue/Clip Store functions.
This illuminates to indicate that the Mark In and Mark Out points have been
defined are waiting to be stored. The SloMoPro is waiting for the user to
press the Enter or CLR/ESC button. Refer to the Cue Operations section for
more detail.
Last Cue, Next Cue
Pressing either of these buttons causes the recall the next or previous stored
Cue or Clip. The Cue or Clip is not recalled until the Enter button is pressed.
This illuminates to indicate that the Cue is pending and waiting for the user to
press the Enter or CLR/ESC button. Refer to the Cue Operations section for
more detail.
Enter
Pressing this button causes the SloMoPro to act on the pending operation.
In Manual Time entry, it causes the SloMoPro to command the video device
to locate to the manually entered timecode, if it is valid and exists.
In Last Cue/Next Cue recall (in Cue and Park mode), it causes the SloMoPro
to command the video device to locate to the stored timecode, if it is valid
and exists.
In Last Cue/Next Cue recall (in Cue/Play/Stop or CuePlayStop Slo mode), it
causes the SloMoPro to command the video device to locate to the stored In
Point, enter Play or varispeed mode and stop at the stored Out Point. Refer
to the Cue Operations section for more detail.
The Enter button is also used in the Configuration Menu to switch between
the menu item and the parameters.
Numeric Keypad
Pressing these buttons allow you to directly access Cues and Clips. They
also allow you to enter timecode for Manual Time. Refer to the Cue
Operations section for more detail.
SloMoPro RS422 User Manual
15