JLCooper Electronics SloMoPro User Manual page 40

To enable all the ports on the GangWay4,
GangWay16 or GangWay32 for output, press the
All On button. The display will show:
To disable all the ports on the GangWay4,
GangWay16 or GangWay32 for output, press the
All Off button. The display will show:
To receive data (such as Timecode or Status)
back from the video device, a port for Tally
operation must be selected. This can be done
by pressing the Tally button. Pressing Tally will
illuminate the Tally LED and cause the display to
show the following:
The down pointing arrow will indicate the port that is configured as the Tally port or
the port that the SloMoPro listens to for Timecode and Status responses.
As with the Enable function, to enable a port on the GangWay for Tally, make sure
that the Tally LED is illuminated then, key in the 2 digit entry on the numeric keypad
for the port.
For example, to select Port 9 for Tally, press 0, 9.
The display will be similar to the screen shot
below. Since the GangWay4 only has 4 ports,
no buttons will illuminate.
To remove the GangWay4, GangWay16 or
GangWay32 configuration pages, simply press
the Enable button. This will cause the display to
revert to normal operation.
SloMoPro RS422 User Manual
40
1234567890123456
↑↑↑↑↑↑↑↑↑↑↑↑↑↑↑↑
1234567890123456
1234567890123456
!
1234567890123456
!
TC= 02:35:52:18