Table of Contents
Advertisement
Pinout
SloMoPro to Video Device
The table below details the pinout of the cable included with the SloMoPro.
Note: Some video devices do not use pin 1 for ground so you may have to connect pin 1 at
each end of the SloMoPro cable to pins 4 and 6 on your video device.
The data transmission from the SloMoPro follows the standard P2 specification.
EIA RS-422A at 38400 bits/sec, 8 data bits, 1 stop bit and odd parity.
The table below details the pinout of the 25 pin cable included with the SloMoPro.
SloMoPro
Function
Receive A
Transmit B
Receive B
Transmit A
If the cable is damaged or lost, it can be ordered from JLCooper Electronics
directly. The JLCooper Part number is 620031.
SloMoPro to SloMoPro / SloMoPro to Computer
To connect two SloMoPro controllers together, an RS-422A crossover adapter or
cable will be needed. An adapter is available from JLCooper Electronics by
ordering p/n 620026. An RS-422A crossover cable can be made by using the
following pinout:
These are
tied together
Note: pins 1, 4, 6 and 9 are grounds and are connected together at each end.
Note: pins 1, 4, 6 and 9 are grounds and are connected together at each end.
Note: pins 1, 4, 6 and 9 are grounds and are connected together at each end.
Note: pins 1, 4, 6 and 9 are grounds and are connected together at each end.
SloMoPro RS422 User Manual
SloMoPro
Function
Ground
Receive A
Transmit B
Receive B
Transmit A
Port 1
Ground
21
22
10
9
23
1,4,6,9
2
3
7
8
Ports 1,2,3,4
1
2
3
7
8
Port 2
Port 3
Port 4
11
16
25
17
12
5
13
4
24
18
1,4,6,9
8
7
3
2
44
6
20
7
8
19
These are
tied together
Advertisement
Table of Contents
