Table of Contents
Advertisement
6. T-Bar Speed Max
This sets the maximum speed to be sent by the T-Bar in Normal Mode when the
T1 (Scaling) button is active.
Note: Due to limitations of the P2 protocol, these speeds may not be exact.
•
1x
•
1½x
7. T-Bar Speed Preset
Sets the Preset Speed to be evoked by pressing the Preset Button.
Note: Due to limitations of the P2 protocol, these speeds may not be exact.
•
Still
•
1/64x
•
1/32x
•
3/64x
•
1/16x
•
3/32x
8. T-Bar Message
This sets the type of command sent by SloMoPro during T-Bar operations
•
Jog Msgs
•
Variable Msgs
•
Shuttle Msgs
9. Stop --> T-Bar
This determines if pressing the STOP, PLAY, R-PLAY, REW or FFWD button will
disable the T-Bar and turn off ENABLE LED.
•
No Effect
•
Turns Off
10. Step Frame
This determines what will happen when a Frame+1 or Frame-1 button is pushed.
•
GoTo Mode
This will issue a GoTo to the proper frame. This should be used with
most "modern" machines, as it can cause inaccurate locating with older
machines such as the BVU-800.
•
SloMo Mode
This issues a slow shuttle command in the appropriate direction, then a
Still command when the desired frame has been reached. This does not
work well with disk-based recorders.
•
Step Fwd/Rev
This sends a 2x 14 or 2x 24 command that is recognized by only very
new machines.
SloMoPro RS422 User Manual
•
2x
•
4x
•
1/8 x
•
3/16x
•
1/4x
•
3/8x
•
1/2x
•
3/4x
18
•
8x
•
10x
•
1x
•
1½x
•
2x
•
4x
Advertisement
Table of Contents
