Machine Control - JLCooper Electronics SloMoPro User Manual

Universal slomo controller

Hide thumbs Also See for SloMoPro:

Table of Contents

SloMoPro RS422 User Manual

Machine Control

Any combination of four machines may be controlled by the SloMoPro. The four

buttons labeled "Machine Control" indicate and modify the machines that will

receive commands. Pressing a single button will switch both the output of the

SloMoPro and the tally back to it to the selected machine. If more than one button

are held down, all SloMoPros will receive commands from the SloMoPro. In this

case, the ﬁrst one pushed will become the machine used for Tally operations

(current time code, transport control LEDs, and Edit Presets.) In a multi-machine

operation, the selection of tally machine made during the output select process may

be overridden by holding down the Rec/Shift button, then selecting a machine. As

soon as the Rec/Shift button is held, the current tally machine will be displayed.

Upon power-up, the SloMoPro will always start with machine #1 selected unless the

menu item Mach 1 Control is set to Disabled. In that case, the SloMoPro will start

up with machine #2 selected.

Table of Contents