GangWay Controls
When GangWay Operation is enabled in
the menu, the Machine Control buttons
and LEDs are repurposed to control the
GangWay4, GangWay16 or GangWay32
(Ports 1-16 only). In this case, the
functions of the buttons and LEDs are as
follows:
Labeling
Since the default labeling of these four buttons is for the Machine Control
function, a plastic decal (shown below) is supplied with the unit that allows
the labeling of the buttons with the GangWay functions. If desired, this decal
can be applied the SloMoPro
above the four Machine Control as
shown above to clarify the
operation of these buttons and
LEDs.
Enable
Pressing this button enters the GangWay4, GangWay16 or GangWay32
configuration mode. In this mode, the Enable LED will illuminate and the
VFD will show the GangWay4, GangWay16 or GangWay32 routing.
All On
When this button is pressed, the GangWay is configured to enable all 16
ports.
All Off
When this button is pressed, the GangWay is configured to disable all 16
ports.
Tally
Pressing this button allows you to select the port, which provides Tally
information (timecode, status) to the SloMoPro. In this mode, the Tally LED
will illuminate and the VFD will show the GangWay4, GangWay16 or
GangWay32 Tally routing.
SloMoPro RS422 User Manual
!
!
38