Table of Contents
Advertisement
Controlling the GangWay
To control the GangWay4, GangWay16 or
GangWay32, simply press the Enable button.
The Enable LED will illuminate and the display
will show similar to the screen shot below.
The top line indicates the ports of the
GangWay4, GangWay16 or GangWay32, 1 =
Port 1, 2 = Port 2 and so on. Starting with 10,
only the last digit is shown due to space
constraints. In this case, 0 = Port 10, 1 = Port
11 and so on.
The bottom line indicates which ports are enabled. The presence of an arrow
pointing up indicates that a port is enabled for output. While the absence of an
arrow indicates the port is not enabled for output.
To enable or disable a port on the GangWay,
make sure that the Enabled LED is illuminated
then, key in the two digit entry on the numeric
keypad for the port. For example, to toggle the
state of Port 6, press 0, 6. The display will be
similar to the screen shot below. In addition, the GangWay16 or GangWay32 will
illuminate buttons 1 and 6. Since the GangWay4 only has 4 ports, only button 1 will
illuminate.
This indicates that Ports 1 and 6 are enabled for output that is, commands from the
SloMoPro will be sent to video devices connected to Ports 1 & 6.
Similarly, to disable Port 1 in the above example,
press 0, 1. The display will show similar to the
screen shot below and the GangWay will now
only illuminate button 6. Since the GangWay4
only has 4 ports, no buttons will illuminate.
To enable Port 12 in the above example, press 1,
2. The display will show similar to the screen
shot below.
SloMoPro RS422 User Manual
39
1234567890123456
↑
1234567890123456
↑
1234567890123456
↑
↑
1234567890123456
↑
1234567890123456
↑
↑
Advertisement
Table of Contents
