Table of Contents
Advertisement
Cue Operations
There is nonvolatile storage on the SloMoPro for 1000 cues or 400 clips. These are
numbered 000 – 999 or 000 - 399. The various operations involving cues are as
follows:
Basic Cue Operations
To Goto a Predefined Cue #
1. Enter the 1,2 or 3 digit number: the time will show on line #2 of the display,
while the entry is shown on line #1.
2. Press Enter. A locate command will be issued, and the top line will revert to
showing current time.
Note: If Preroll is enabled, that will be applied to time.
3. The next action will depend upon the Cue Operation mode that the
SloMoPro is configured for.
•
If in Cue and Stop mode, the controller does nothing.
•
If in Cue/Ply/Stop mode, the controller will send a Play command when
Mark In point is reached (minus any Preroll), and will send a Stop
command when the Mark Out point is reached.
•
If in CuePlyStopSlo mode, the controller will send a Variable Play
command when Mark In point is reached (minus any Preroll), and will
send a Stop command when the Mark Out point is reached.
4. Pressing the CLR/ESC button will exit the cue entering process, but will
allow the entered cue to remain "pending" for possible Cue/Ply/Stop time
capture operation.
Next Cue
Pressing this will bring up the next higher cue from the last entered or used. The
time stored in this Cue location will be displayed on the second line. Multiple
presses of this will scroll thru the Cues.
•
Pressing Enter will cause the currently displayed Cue to be sent.
•
Pressing the CLR/ESC button will exit back to normal operation without
sending the Cue.
Last Cue
This operates the same as above, except that the Cue number is decremented with
each push.
Current Cue
Pressing the ENTER key will replay the most recently selected cue. This may be
done repeatedly.
SloMoPro RS422 User Manual
27
Advertisement
Table of Contents
