Commands - JLCooper Electronics SloMoPro User Manual

operator to start the recorder at the beginning of an event and then locking out
the controls to prevent the accidental stopping of the record process.
• Disabled
• Enabled
22. GangWay Oper.
Enables or disables control of an optional JLCooper Electronics GangWay16 or
GangWay32 RS-422 router. Enabling this option repurposes the 1, 2, 3 & 4
buttons and LEDs below the T-Bar for remote control of the GangWay16 or
GangWay32. See the section on GangWay Operation.
• Disabled
• Enabled

Commands

23. Ply All Clips
This allows the automatic playback of valid and enabled cues, starting with the
currently selected one. When a blank cue is reached, the operation ends. A
blank cue is defined as a cue with a stop time = 00:00:00:00, which is the
internal condition of erased cues. You must be in Cue/Play/Stop or CuePlyStp
Slo modes for this operation to take place! After each cue is played, the
controlled SloMoPro will stop for a period set by the Cue Delay Time, and then
proceed to the next cue.
• ENTER
When the ENTER key is pressed to initiate this command, a message
appears prompting the operator to place the destination video device into
record mode. Press ENTER again to begin the playout of clips.
• W1 or W2
By selecting the W1 or W2 button to be "Tog Clip Enable", it is possible.
• CLR/ESC
Pressing the CLR/ESC button at any time aborts the operation.
24. Ply Odet Clips
This the same as Play All Cues, except that it uses the Odetics protocol to
accomplish the playback. All other description of Play All Cues is valid.
25. Xmit Cue List
Pressing the ENTER key causes all non zero cue location data to be sent over
port #4 to either another SloMoPro SloMoPro or a computer. When attaching to
another SloMoPro SloMoPro, a special RS-422A crossover cable is necessary.
When attaching to a computer, as RS-422A port or RS-422A to RS-232
converter is necessary.
When the SloMoPro is in Cue and Park mode, the data format conforms to the
Ash Vale SM-2a protocol. When the SloMoPro is in Cue/Ply/Stop or
CuePlyStopSloMo mode, the data format is unique to the SloMoPro.
Both formats are detailed in the appendix.
SloMoPro RS422 User Manual
22