Table of Contents
Advertisement
Operating instructions
4.2.3 Manual operation
When the machine has stopped and you do not wish to wait for automatic
unloading, manual mode can be used to transport the items out of the machine.
Button (b) must be pressed for manual operation. The start button (a) must also
be pressed if the machine has stopped.
If the machine is being operated in manual mode and new trays are fed in, the
machine switches to automatic operation automatically.
4.2.4 Storage in the dispenser
If washed trays are being stored in the tray dispenser connected to the machine's
outfeed, a yellow alarm is displayed on the touch panel when the dispenser is full.
The machine stops. A full dispenser can also be indicated with an alarm lamp (6)
(option).
If the machine is connected to a tray exchanger for two dispensers, a yellow alarm
is displayed when both dispensers are full.
When empty dispensers are put in position, the machine starts automatically.
4.2.5 Cleaning the filters
The machine can also be fitted with an alarm lamp (8) as extra equipment which
indicates that the filters in the chemical wash tank are clogged with dirt and need
to be cleaned. Dirty filters can affect the washing results. If the alarm is activated,
remove and clean the filters.
4.2.6 Emergency stop
The machine has an emergency stop (2), which is located under the touch panel
and the ON/OFF button.
If an emergency stop button is pressed during operation, the reason for the
emergency stop must be rectified. The emergency stop is then reset by turning
the emergency stop button in the direction indicated by the arrows on the
emergency stop button. You must reset the alarm on the touch panel before you
can restart the machine.
4.2.7 Guaranteed final rinse
The temperature of the final rinse water is always correct and the right amount of
rinse water is always used.
If there is an error during the final rinse, this is indicated by an alarm and
information on what must be done.
WD-40BRE
31
Rev. (202303)
Advertisement
Table of Contents
