Table of Contents
Advertisement
Installation
3.2.4 Space for servicing
3.3 Transport and storage
The area above the machine must not contain any equipment which could pre-
vent the fitting, servicing and replacement of parts. A free height of at least 2.8
metres is required in order to remove the inspection doors.
A 1-metre free space should be allowed in front of the machine and around the
infeed and outfeed ends for service purposes.
Check that there is sufficient height available to transport the machine to its instal-
lation site.
The machine is supplied in sections with a pallet under each section. Transport
each section to the installation site using a handtruck.
The sections are transported transversely with the forks of the truck inserted from
the long side. (The side marked "FRONT"). If the space available does not permit
transverse transport, each section should be transported using two handtrucks,
one at each short end. Do not lift the machine where its legs are positioned. These
positions are indicated by labels on the outside of the packaging.
Lyftanvisn
Label which marks the position of the legs
Take care during transport, as there is a risk of the equipment tipping over.
NOTE: The machine must not be transported without a pallet or other support,
Some form of support beam must always be used along the sides of the machine
during transport. otherwise the machine may become damaged. When transport-
ing the machine without an ordinary pallet, always check that none of the compo-
nents underneath the machine can be damaged.
If the machine is not to be installed immediately, it must be stored in a frost-free
area where the air is dry.
WD-59CT & WD-66CT
7
Rev. 2.0 (20110124)
Advertisement
Table of Contents
