Table of Contents
Advertisement
Operating instructions
4.2.4 Storage in the tray dispenser
4.2.5 Cancelling washing
4.2.6 Emergency stop
4.2.7 Guaranteed final rinse
WD-215T & WD-275T
If washed trays are stored in the tray dispenser connected to the machine's out-
feed end, a message will appear on the touch panel when the dispenser is full of
trays. Change the dispenser. When an empty dispenser is put in place, the ma-
chine is ready to wash again.
The machine can also be connected to a tray exchanger for two dispensers.
When one dispenser is full, the trays are automatically switched to the other dis-
penser and the machine does not stop until both dispensers are full.
It is possible to interrupt the wash by pressing Start/Stop (a) on the touch panel.
The dishware can be removed from the machine by pressing (b)
The machine has an emergency stop, which is located on the electrical cabinet.
If an emergency stop button is pressed during operation, the reason for the emer-
gency stop must be rectified. The emergency stop is then reset by turning the
emergency stop button in the direction indicated by the arrows on the emergency
stop button. You must reset the alarm on the touch panel before you can restart
the machine.
The temperature of the final rinse water is always correct and the right amount of
rinse water is always used.
If there is an error during the final rinse, this is indicated by an alarm and informa-
tion on what must be done.
touch
42
Rev. 00 (202310)
.
Advertisement
Table of Contents
