Table of Contents
Advertisement
Installation instructions
3.3 Transport and storage
Always transport the machine in an upright position.
•
•
•
Label on the packaging marking the position of the legs
If the machine is not being installed immediately, it must be stored in a frost-free
area where the air is dry.
3.4 Unpacking
•
•
•
•
•
•
WD-B 550S - WD-B 950S
Take care during transport, as there is a risk of tipping. N.B.! The machine
must not be transported without a pallet or other support. Some form of
support beam must always be used along the sides of the machine during
transport. Otherwise the machine may become damaged. When
transporting the machine without a normal wooden pallet, always check
that none of the components underneath the machine can be damaged.
The machine is supplied in sections with a pallet under each section.
Transport each section to the installation site using a handtruck.
The sections are transported transversely with the forks of the truck
inserted from the long side (the side marked "FRONT"). If the space
available does not permit transverse transport, each section should be
transported using two handtrucks, one at each short end. Do not lift the
machine by its legs. These are indicated by labels on the outside of the
packaging.
Check against the delivery note that all the units have been delivered.
Remove the packaging, but leave the pallet and any transport supports in
place.
Packaging must be sent for destruction or recycling in accordance with
local regulations.
Inspect the machine for any transport damage.
Lift the section at both ends using a handtruck. Screw down the legs (B) so
that they extend below the bottom of the pallet (C). Lower the section. Split
the pallet and remove it.
If the section should need to be lifted again from the short sides, a wooden
runner should be placed under the cross-bar (A) on the section stand.
10
Rev. (202209)
Advertisement
Table of Contents
