Table of Contents
Advertisement
Installation instructions
3.7 Trial operation
Prepare the machine for trial operation with the help of OPERATING INSTRUC-
TIONS. The instructions describe the measures that must be taken to prepare the
machine for operation.
3.7.1 Commissioning protocol
This should be completed when the machine is started up and used.
Read the installation and user manuals carefully. Then check the following points:
1. Check:
•
•
•
•
•
•
•
•
2. Filling the machine:
•
•
•
•
3. Check the setting of the reference values:
•
•
Machine type:
Machine serial number:
Installation date:
Water, steam and drain connections
That the machine is evenly balanced
That closed doors are in line
That the benches, conveyor bend etc. are correctly fitted
Detergent and drying agent
That the filters, level pipe, filter tray and curtains are in position
The mini-switches for all the heating elements must be in the OFF position.
That the overheating protection device is reset
Close the doors
Switch on the main switch and press 0/1
Fill the machine with water in accordance with the OPERATING INSTRUC-
TIONS
Note: It takes approximately 10 minutes to fill the system. The booster
heaters fill automatically when the doors are closed. The machine has a fill-
ing check function for the booster heaters. When the function is activated,
a check is carried out to ensure that the booster heaters are full of water,
before the element is switched on.
Note: If the filling process is interrupted using the main switch, the check
starts again from the beginning.
When the filling check has been completed and all the tanks are full, the
mini-switches for the booster heaters switch on.
All the reference values have been set to the recommended values on de-
livery
Check that the motor cut-off switch for the infeed and outfeed conveyors
have been set correctly
WD-153 - WD-423
optiflow
30
Rev. 00 (202310)
Advertisement
Table of Contents
