Table of Contents
Advertisement
Installation instructions
3.9 Trial operation
Prepare the machine for trial operation with the help of OPERATING
INSTRUCTIONS. The instructions describe the measures that must be taken to
prepare the machine for operation.
3.9.1 Commissioning protocol
This should be completed when the machine is started up and used.
Read the installation and user manuals carefully. Then check the following points:
1. Check the following before starting the dishwasher:
•
•
•
•
•
•
•
•
•
2. Filling the dishwasher:
•
•
•
•
•
•
•
•
WD-40BRE
Machine type:
Machine serial number:
Installation date:
Water and waste pipe connections
That the overheating protection device is reset
The dishwasher is connected with the correct phase sequence.
That the machine is evenly balanced
That the closed doors are in line
that the mini switches for tank heaters (FU22 - FU24), booster heaters
(FU41 - FU43) and drying zone (FU31 - FU33) are in the OFF position
(other mini switches must be turned on).
The equipment for detergent and drying agent are correctly connected
The adaptation of any tray dispensers
That the filters, outlet seals, level pipes, curtains and filter tray are in place
in the dishwasher
Start the dishwasher
Check the pump's direction of rotation
Close the doors
Fill the dishwasher with water
Check the temperature of the incoming hot and cold water during filling
(see the Technical Specifications in the Installation and User Manual).
Check the water flow and water pressure for the incoming hot water. Inform
the customer if the water flow and the water pressure are too low!
Check that the times for
- filling of tanks
- heating of tanks
- detergent mixing
are correct (see Adjustment instructions)
Turn on the mini switches for the tank heater, booster heater and drying
zone heater once the fill check for the booster heater is complete and the
dishwasher starts.
19
Rev. (202303)
Advertisement
Table of Contents
