Table of Contents
Advertisement
Installation instructions
3.9 Trial operation
Prepare the machine for trial operation with the help of OPERATING
INSTRUCTIONS. The instructions describe the measures that must be taken to
prepare the machine for operation.
3.9.1 Commissioning protocol
This should be completed when the machine is started up and used.
Read the installation and user manuals carefully. Then check the following points:
1. Check the following before starting and filling the dishwasher with water:
•
•
•
•
•
•
•
•
•
2. Filling the dishwasher with water:
•
•
•
•
•
•
•
Machine type:
Machine serial number:
Installation date:
Air, water and waste pipe connections
The machine is connected with the correct phase sequence
The overheating protection devices are reset
The rotating table is correctly adjusted vertically
The support rollers on the rotating table have a few millimetres' clearance
The washing machine is horizontal
Any equipment for detergent and drying agent is correctly connected
Pump strainers, level pipes and filter trays are correctly in place
For electrically-heated machine: FU21, FU41 (option) and FU42 mini-
switches are in the OFF position
Check that the distance between the position sensor for the locking arms
and the indicator plate for them is correctly set, and that the indicator plate
screw is properly tightened
Check the locking function of the gates
Open the tap(s) to the dishwasher's water connection and fill the machine
with water (possibly as an option via break tank).
Turn on the mains switch and the machines On/Off button.
Press "PLAY" on the display panel and follow the instructions.
Check the direction of rotation of the pumps
N.B.! If the direction of rotation is wrong, phase inversion of the relay is
required
Turn on the mini-switches FU21 and FU42 when the booster heater and
tank have filled with water
WD-18CW
20
Rev. (202211)
Advertisement
Table of Contents
