Setting Up A Method Using Edit Entire Method - Agilent Technologies 1290 Infinity LC System System Manual And Quick Reference

Setting Up a Method using Edit Entire Method

All method procedures and setups are described for the 1290 Infinity Binary
Pump. They can be executed in an equivalent way for the 1290 Infininty
Quaternary Pump.
A method in the ChemStation contains all the parameters for Data Acquisition
(controlling the system) and Data Analysis (processing the data to give
quantitative and qualitative results). The parameters are accessed through a
series of screens which each focus on one module or function. These screens
are accessed by clicking an icon on the graphical user interface (GUI) or
through the menu bar with its drop-down menus. A new method can be
created by loading and editing an existing method, or it can be created by
loading and editing the blank template method DEF_LC.M.
To change only a few parameters, you can go directly to the relevant setup
pages for the parameters to be altered. Less experienced users may find it
easier to use the Edit Entire Method function as this automatically steps through
the pages. This is accessed through the menu Method > Edit Entire Method, and
opens the Check Method Sections to Edit dialog:
Figure 35
Agilent 1290 Infinity LC System Manual and Quick Reference
Check Method Sections to Edit

Setting Up a Method using Edit Entire Method

6
Appendix
115