Instrument/Acquisition - Agilent Technologies 1290 Infinity LC System System Manual And Quick Reference

6
Appendix
Setting Up a Method using Edit Entire Method

Instrument/Acquisition

Setup Instrument Method
The Setup Method screen can be directly accessed through the menu Instrument
> Setup Instrument Method..., or by right-clicking on the graphical user interface
on any module icon and then selecting Method... in the context menu. This next
stage in Edit Entire Method is the Setup Method screen with six tab dividers for
different modules or functions .
The tabs are:
• High Performance Autosampler (HiP-ALS)
• HiP-ALS Injector Program
• Binary Pump (BinPump)
• Thermostatted Column Compartment (TCC)
• Diode-array Detector (DAD)
• Instrument Curves
To move between the tabs, click on the tab name at the top of the screen. When
parameter changes have been entered they can be immediately sent to the
instrument by clicking Apply or when all tabs have been completed clicking OK
will send all parameters to the modules, close the screen and move on to the
next stage.
The parameter entry tabs look similar in all the control programs
(ChemStation, EZChrom, MassHunter et al.) due to the Agilent concept of
common RC.Net drivers for the instrument modules.
To run the example separation, as with most methods, it is not necessary to
change every available parameter but for completeness they are described in
the next sections.
118 Agilent 1290 Infinity LC System Manual and Quick Reference