E530;Front Aligning Plate Motor Error - Canon Finisher-T1 Service Manual

Chapter 4

4.4.1.4 E530;Front aligning plate motor error

Front aligning plate home position sensor (PI106)
1) Check the front aligning plate home position sensor. Does the sensor operate normally?
NO : Replace the sensor.
Wiring
2) Is the wiring between the finisher controller PCB and front aligning plate motor normal?
NO : Repair the wiring.
Front aligning plate
3) Is there any mechanical trapping in the path of the aligning plate?
YES : Repair the mechanism.
Front aligning plate motor (M103)/Finisher controller PCB
4) Does it improve when the front aligning plate motor is replaced?
YES : End
NO : Replace the finisher controller PCB.
4.4.1.5 E531;Staple motor error
Wiring
1) Is the wiring between the finisher controller PCB and stapler normal?
NO : Repair the wiring.
Stapler/Finisher controller PCB
2) Does it improve when the stapler is replaced?
YES : End
NO : Replace the finisher controller PCB.
4.4.1.6 E532;Stapler shift motor error
Stapler
1) Is the stapler caught in the way of its travel route and is the sensor flag of the stapler alignment interference sensor
(PI116) activated when power is ON?
YES : Manually move the stapler to the position where the sensor flag is not activated.
Stapler drive home position sensor (PI110)
2) Check the stapler drive home position sensor. Does it operate normally?
NO : Replace the sensor.
Wiring
3) Is the wiring between the finisher controller PCB and stapler shift motor normal?
NO : Repair the wiring.
Stapler shift base
4) Is there mechanical trapping in the path of the stapler shift base?
YES : Repair the mechanism.
Stapler shift motor (M105)/Finisher controller PCB
5) Does it improve when the stapler shift motor is replaced?
YES : End
4-10
0009-2591
0009-2592
0009-2593