How To Enter Passcodes - Magtek DynaPro Go Installation And Operation Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Programmer's manual (247 pages) ,
- Installation and operation manual (60 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
7 - Operation
7.10 How to Enter Passcodes
Some device operations require the operator to enter a passcode before the operation can proceed. In
these cases, the device's display prompts the operator to
Enter Admin Passcode
. The operator should
key in
1 3 9 7 2 6 8 4 Enter
. The device shows asterisks masking the passcode the operator is
entering. If the operator makes a mistake, the
button clears the passcode field so the operator can
Clear
start over, and the
button cancels the operation that required the passcode.
Cancel
Figure 7-26 - Passcode Prompt Screens
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 72 of 77 (D998200129-20)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?
Questions and answers