How To Start A Handheld Transaction Using The Bluetooth Le Connection - Magtek DynaPro Go Installation And Operation Manual

7 - Operation
7.5

How to Start a Handheld Transaction Using the Bluetooth LE Connection

To initiate a transaction when the device is connected to the host via the Bluetooth LE connection, follow
these steps:
1) Start the transaction using the point of sale's interface (see the point of sale documentation for
details). After the host establishes a Bluetooth LE connection to the device, the device powers on
automatically. If it does not, power on the device manually, make sure the device's active connection
is set to Bluetooth LE (see section 7.2 How to Read Device Status and section 6.3 How to Change
the Active Connection), and make sure the device is advertising (see section 7.3.5 How to Turn
Bluetooth LE Advertising On and Off).
2) Depending on how the host software is designed, the host sends various messages requesting that the
cardholder or operator enter additional information, and the device requests payment as described in
section 7.6 Card Reading.
3) Upon completion of the transaction, the host software should close the Bluetooth LE connection.
After a short period of time, the device powers off automatically to conserve power.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 63 of 77 (D998200129-20)