How To Test A Device Initiated Wireless Connection - Magtek DynaPro Go Installation And Operation Manual

Handheld pin pad device with msr/contact/contactless

Hide thumbs Also See for DynaPro Go:

Table of Contents

6 - Configuration

6.4.5.2 How to Test a Device Initiated Wireless Connection

The SDK does not provide tools for testing the 802.11 wireless connection when the device is in Device-

Initiated mode. To test the device in this mode, use the actual host that will be used in the solution:

1) Make sure the network, host, and device are properly configured (see previous sections).

2) Test that there is adequate signal strength between the access point and all locations where the device

will operate wirelessly. In each location, open the Connection Status Screen and make sure the

Received Signal Strength Indicator level (

3) Follow the steps in section 7.4 How to Start a Handheld Transaction Using 802.11 Wireless.

DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual

) is greater than

RSSI

Page 46 of 77 (D998200129-20)

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the DynaPro Go and is the answer not in the manual?