How To Power On / Power Off - Magtek DynaPro Go Installation And Operation Manual

7 - Operation

7.3.3 How to Power On / Power Off

The device powers on in several ways:

An operator presses and holds the

An operator connects the device to USB power.

The host establishes a Bluetooth LE connection. This only works if the device is advertising (see
section 7.3.5 How to Turn Bluetooth LE Advertising On and Off).
After powering on, the device displays the
How to Read Device Status).
The device powers off in several ways:

The operator presses the
/ selection, then presses the function key below
No
Powering Off...
displays a
device implements a Bluetooth LE connection, it continues to advertise. While on the prompt screen,
the operator may also cancel powering off and return to the
or by pressing the function key below

If the device has a Bluetooth LE connection, it powers off automatically a few seconds after the host
closes the connection.

If the device implements a Bluetooth LE connection, it powers off automatically if the host does not
have an active Bluetooth LE connection and there has been no operator or cardholder activity during
a configurable timeout period.

The operator resets the device as described in section 7.3.4 How to Reset the Device.

The device powers off automatically to conserve power when it does not have an active connection to
the host and is not connected to USB power, and there has been no operator or cardholder activity
during a configurable timeout period. The device shows
display turns off. To wake it up, press and hold the
it to USB power.
Figure 7-12 - Device Powering Off Automatically After Timeout
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Power button
Welcome
for two seconds to display a
Power button
screen for three seconds before the display turns off. In this mode, if the
.
No
Page 59 of 77 (D998200129-20)
for one to two seconds.
screen and the current device status (see section 7.2
Power Off?
. While the device is powering off, it
Yes
Welcome screen by waiting 10 seconds
Sleeping...
for three seconds before the
for one to two seconds or connect
Power button
screen with a
Yes