How To Configure The Lcd Display Brightness - Magtek DynaPro Go Installation And Operation Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Programmer's manual (247 pages) ,
- Installation and operation manual (60 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
6 - Configuration
6.1
How to Configure the LCD Display Brightness
The device's LCD display has a backlight that can be configured to either remain at a constant user-
selected brightness level (Manual mode) or adapt its brightness to ambient lighting based on the device's
light sensor (Auto mode). The factory default of the device is
mode at
brightness.
Manual
75%
To change the LCD display backlight mode, on the
screen, press
Welcome
Left Function Key 5 2 2
Right Function Key
to open the
LCD Brightness Config
screen.
The
screen shows the mode the LCD display backlight is currently using. To
LCD Brightness Config
change the mode, press the function key below the selection you want, then press the
key to save
Enter
the change. To exit without saving changes, press the
Cancel
key or wait 10 seconds for the device to
return to the
Welcome
screen.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 30 of 77 (D998200129-20)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?
Questions and answers