Major Components; About Terminology - Magtek DynaPro Go Installation And Operation Manual

2 - Introduction
2.9

Major Components

The major components of DynaPro Go are shown in Figure 2-1. In addition to the components shown,
the device has a tamper trigger recessed in the bottom that is intended for manufacturer use only.
Do not insert anything into the tamper trigger hole! Doing so will erase all injected keys;
the device will stop functioning, and will have to be returned to the manufacturer for re-
configuration.

2.10 About Terminology

In this document, DynaPro Go is referred to as the device. It is designed to be connected to a host, which
is a piece of general-purpose electronic equipment which can send commands and data to, and receive
data from, the device. Host types include PC and Mac computers/laptops, tablets, and smartphones.
Generally, the host must have software installed that communicates with the device and is capable of
processing transactions. During a transaction, the host and its software interact with the operator, such
as a customer service representative, while the device interacts with the cardholder (even if the
cardholder is using a virtual representation of the card account, such as a smartphone).
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Figure 2-1 – DynaPro Go Major Components
Page 15 of 77 (D998200129-20)