Magtek DynaPro Go Installation And Operation Manual page 50

7 - Operation
The device may show text other than "Welcome" under certain conditions:

No Host Connection
Bluetooth LE, but the device is not yet connected to a host.

instead of "Welcome" appears when the Network Connection Mode is set to
Waiting for Host
Device Initiated, and the device has sent the initial request to the host for it to call back and establish
a secured connection.

instead of "Welcome" means the device is not ready for normal operation. When this
OFFLINE
occurs, the display shows a reason code in the lower right corner. Codes that start with
S indicate a problem that requires the device be returned to the supplier for service or replacement.
Table 7-2 provides full explanations of the prefixes of all
DYNAPRO GO PROGRAMMER'S MANUAL (COMMANDS) provides detailed explanations of
every individual numerical code, geared toward solution designers.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Figure 7-3 - Welcome Screen Example
instead of "Welcome" means the device's Active Connection is set to USB or
Figure 7-4 - Welcome Screen Showing OFFLINE
Page 50 of 77 (D998200129-20)
codes. D998200136
OFFLINE
, , , or
C H K