Magtek DynaPro Go Installation And Operation Manual page 27

5 - Installation
8) If the passcodes on the host and device match, press the function key below
request, and perform any corresponding actions on the host. The device shows a confirmation screen
for a short time to indicate the operator has accepted the request. If the passcodes do not match, press
the function key below
9) If pairing fails for any reason, the device will refuse pairing requests even if the countdown is still
active. To attempt pairing again, repeat the steps above, starting with the key sequence to enable
pairing.
10) Make sure the device is connected to the host by checking the device's status icons (section 7.2 How
to Read Device Status) or Connection Status Screen.
11) The device stays powered on until the host terminates the Bluetooth LE connection, or until an
operator or cardholder powers off the device using the power button (see section 7.3.3 How to Power
On / Power Off). Powering off causes the device to close the Bluetooth LE connection, but the
device continues to advertise so the host can re-establish a connection and power on the device
automatically when needed. To conserve power, make sure the device is powered off either
automatically or manually when it is not in use.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
and try again.
No
Page 27 of 77 (D998200129-20)
to accept the pairing
Yes