How To Test The 802.11 Wireless Connection - Magtek DynaPro Go Installation And Operation Manual

6 - Configuration

6.4.5 How to Test the 802.11 Wireless Connection

To test the device's wireless connection regardless of whether it is configured for Always Listening or
Device Initiated mode, follow these steps:
1) Obtain the device's IP address using
2) Open a command prompt on the host and enter
device's display. If the request times out, the network connection is not working.
3) To test that the device's DNS name is properly registered with the DNS server, follow these
additional steps:
a) Obtain the 16-character device serial number from its label, and prefix it with the string
form a 19-character device name.
b) In the command prompt, enter
name. If the request times out, the device is not registered with the DNS server, and the host will
only be able to reach it using the numerical IP address.
4) If the device is configured for Always Listening, continue testing by following the steps in section
6.4.5.1 How to Test an Always Listening Wireless Connection. If the device is configured for
Device Initiated, continue testing by following the steps in section 6.4.5.2 How to Test a Device
Initiated Wireless Connection.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Left function key ,
ping xx.xx.xx.xx
ping TLSxxxxxxxxxxxxxxxx
Page 43 of 77 (D998200129-20)
4 , 7 , 2 , Right function key
where xx is
IP Addr
where TLSxxx... is the device
.
from the
to
TLS