Magtek DynaPro Go Installation And Operation Manual page 41

6 - Configuration
19) To configure the device to use DHCP and a dynamic IP address, turn off the
press the button. To configure the device to use a static IP address, follow these steps:
Set
a) In the section of the
Device
b) Select
Static IPv4
c) Select
Gateway
d) Select
Subnet Mask
e) Press the button to save all settings to the device.
Set
20) If the Network Connection Mode is Device Initiated, configure the device to connect to the correct
listening host using the
a) Use the Host dropdown list to select whether the device should connect to the host by DNS
name or by static IP address.
b) Fill in the host Port
c) Fill in the host's IP address or DNS name.
d) Press the button to save the settings to the device.
Set
21) Make sure the 802.11 wireless access point is configured and available before proceeding.
22) Change the Active Connection to 802.11 Wireless (see section 6.3 How to Change the Active
Connection). The screen shows a wireless network icon at the top to indicate that the current active
connection is 802.11 wireless (see section 7.2 How to Read Device Status).
23) If the access point is available, the device shows
successfully connects to the access point, shows
access point, it shows
Screen).
24) On the screen, press
Welcome
shows a page about the 802.11 wireless connection.
25) Write down the IP Address
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
tab, turn on the checkbox for
Wireless
in the dropdown list, and fill in the desired
Setting
in the dropdown list, and fill in the desired Gateway IP address.
Setting
in the dropdown list, and fill in the desired Subnet Mask.
Setting
box:
Host Type
to use when initiating a connection.
and error codes specifying why (see section 7.2.1 Welcome
OFFLINE
Left function key
and press the Cancel
Page 41 of 77 (D998200129-20)
Connecting Wireless
Welcome . If the device can not connect to the
, , , ,
4 7 2 Right function key
key to return to the Welcome
checkbox and
Static IP
.
Static IP
and IP address.
Port
on the display, then if it
. The device
screen.