About Software; About Connecting To A Host; How To Connect Dynapro Go To A Host Or Charger Via Usb - Magtek DynaPro Go Installation And Operation Manual

5 - Installation
5.2

About Software

In any solution, DynaPro Go is connected to a host, which must have software installed that knows how
to communicate with the device, and which is capable of processing transactions. To set up the host to
work with DynaPro Go, follow the installation and configuration instructions provided by the vendor of
the host or the host software. For information about developing custom host software, see section 9
Developing Custom Software.
5.3

About Connecting to a Host

The following sections provide steps for connecting DynaPro Go to a host via the various available
physical connection types.

5.3.1 How to Connect DynaPro Go to a Host or Charger via USB

Figure 5-1 - Connecting DynaPro Go to a USB Host or USB Charger
To connect DynaPro Go to a USB host or charger using the micro-USB port, follow these steps:
1) In any order:

Connect the small end of the USB cable to DynaPro Go as shown in Figure 5-1.

Connect the large end of the USB cable to the charger or to the host's USB port.
2) As soon as DynaPro Go starts receiving power through USB, it automatically powers on.
3) If you want DynaPro Go to communicate with the host via USB (as opposed to merely using it as a
power source to charge the battery), make sure its active connection is set to USB. See section 6.3
How to Change the Active Connection.
4) If the specific DynaPro Go serial number you are connecting has not been connected to the host
before, the device shows
host reports it is
Installing device driver software
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
on the display, and the Windows system tray on the
No Host Connection
Page 23 of 77 (D998200129-20)
.