How To Charge The Battery - Magtek DynaPro Go Installation And Operation Manual

7 - Operation

7.3.2 How to Charge the Battery

DynaPro Go has an onboard rechargeable battery to supply its own power when it is not powered through
its USB port. The battery must be periodically recharged by connecting it to the available charging
cradle, or to a USB port or stand-alone USB charger. Both the charging cradle and the device require a
USB power supply that can provide at least 500mA @ 5V.
To charge the device using a micro-USB cable, connect it to a USB charger, or to a USB host as shown in
section 5.3.1 How to Connect DynaPro Go to a Host or Charger via USB on page 23.
To charge the device in the charging cradle for power only (no USB communication):
1) Connect the charging cradle to a USB port or to a USB charger.
2) Place the device in the charging cradle with the charging contacts pointing into the charging cradle
and the LCD display facing front.
Figure 7-11 - Device In Charging Cradle
A full recharge cycle for a completely drained battery takes approximately 6 hours.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 58 of 77 (D998200129-20)