Connection Status Screen - Magtek DynaPro Go Installation And Operation Manual

7 - Operation

7.2.6 Connection Status Screen

In addition to the icons at the top of the display, the device has a
screen that reports deeper details about the device's 802.11 wireless or Bluetooth LE connection. To
access it, on the Welcome
. This brings up a screen similar to the figures below. To return to the
key
key.
Cancel
For compatibility with similar MagTek devices, this screen may also launch with keystrokes
function key 4 7 2 Right function key
In addition to information about the device, the
currently advertising (
Advertising Active
( Connection Active ), and whether the host has secured that connection and configured it to properly
communicate with the device (
device can process transactions. It is normal for the device to stop advertising after the host has
established a connection. The
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
screen, press the sequence
Figure 7-9 - 802.11 Wireless Status Screen
Figure 7-10- Bluetooth LE Status Screen
.
Bluetooth Status
), whether the host has established a Bluetooth LE connection
Connection Ready
value is reserved for future use.
Error
Page 56 of 77 (D998200129-20)
Wireless Status
Left Function Key ,
screen shows whether the device is
).
Connection Ready
or Bluetooth Status
6 , 2 , 2 , Right function
screen, press the
Welcome
Left
must show before the
Yes