Lcd Display Brightness Auto Mode; Lcd Display Brightness Manual Mode - Magtek DynaPro Go Installation And Operation Manual

6 - Configuration

6.1.1 LCD Display Brightness Auto Mode

When the display brightness is set to
automatically based on ambient light detected by the light sensor (see section 2.9 Major Components).
The brightness levels the device selects are shown in Table 6-2. When the device is in
key combination to manually set LCD brightness is not available.
Table 6-2 - LCD Display Brightness Levels
Light Level LCD Brightness Level
High Maximum (99%)
Medium High (75%)
Low Medium (60%)
Very Low Low (45%)

6.1.2 LCD Display Brightness Manual Mode

When the display brightness is set to
constant level the user can select. The factory default is
brightness level, on the
show the Adjust LCD screen.
Select the desired brightness by pressing the
key to save the change. To exit without saving changes, press the
Enter
for the device to return to the
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Auto mode, the device adjusts the LCD backlight brightness
Manual mode, the device keeps the LCD backlight brightness at a
screen, press
Welcome
key to decrease and the
1
screen.
Welcome
Page 31 of 77 (D998200129-20)
(75% brightness). To change the constant
High
Left Function Key 5 2 3 Right Function Key
3
Auto mode, the
key to increase, then press the
key or wait 10 seconds
Cancel
to