Configuring A Dhcprelayagent; Lan Settings For Dhcpserver - Nortel Enterprise Edge 2.0 Programming Manual

194 Configuring Enterprise Edge Services

Configuring a DHCPRelayAgent

If you choose DHCPRelayAgent as the mode, the Global Options screen and Server
List appear and the Configuration menu is enabled.
1. Choose what the log displays, Errors Only, Warnings Also, Maximum or
Disabled. The default is Errors Only.
2. On the Configuration menu, click Add server.
The Server list dialog box appears.
3. Type in the IP Address of the server.
Note: You can specify a number of servers. The routing component searches
the list for the server on the same subnet as the interface and forwards
the packet.
4. Click Save.

LAN settings for DHCPServer

If you configured the DHCP mode for DHCPServer in the previous procedure then
configure LAN1 scope attributes as follows. If the mode is DHCPRelayAgent refer
to LAN settings for DHCPRelayAgent
1. Choose Services. Click the DHCP navigation key to expand the navigation
tree.
2. Click on the LAN1 heading.
Note: If your Enterprise Edge system has multiple LAN interfaces, you can
see multiple DHCP scopes under DHCP. They are named LAN1,
LAN2, etc. This section describes configuring the DHCP scope for
LAN1. Follow the same instructions to configure any of the
parameters under the scope for LAN2.
The frame displays the LAN Scope Specific Options, Address Range, and
Excluded Address Range screens.
3. Scroll down to view all settings.
4. Configure the scope-specific settings. Refer to the DHCP LAN attribute table
below.
5. Configure the LAN address range and the LAN excluded address services
screens through the menu. Refer to the DHCP LAN attribute table below.
Enterprise Edge 2.0 Programming Operations Guide
on page 198.
P0911588 Issue 01