Configuring An Interface For Ipx Routing - Nortel Enterprise Edge 2.0 Programming Manual

2. Use the following table to configure the IPX global settings.
The Summary, IPX Global Summary, RIP Global Settings and SAP Global
settings are:
Attribute
Description
Version
Status
Internal Network
Number
IPX Log level
RIP Log level
SAP Log Level
3. Press the Tab key to save the settings.

Configuring an interface for IPX routing

This section provides instructions on how to configure IPX routing for specific
interfaces. All available interfaces (i.e.: LAN2, WAN1, V90-1) appear under the
IPX Routing heading. The same configuration procedures apply to all interfaces.
1. Choose Services, and click on the LAN1 heading (if configuring IPX routing
for traffic on LAN1).
The IPX routing parameters for LAN1 appear.
P0911588 Issue 01
Description
Displays the name of the router.
Displays the version number of the router.
Displays the current status of the service. Possible values are Disabled, Up,
Down. Users can change the status of the service by selecting Disabled or
Enabled. By default, IPX service is Disabled.
Allows you to specify the internal network number. The internal network
number uniquely identifies the computer on the intranet.
Allows you to enable the recording of events in the Event Viewer. The
following options are available:
Maximum, logs all information in the Event Viewer.
Warnings Also, logs errors and warnings in the Event Viewer.
Errors Only, logs errors in the Event Viewer.
Disabled, disables event logs.
The default value is Errors Only.
Allows you to enable the recording of events in the Event Viewer. The
following options are available:
Maximum, logs all information in the Event Viewer.
Warnings Also, logs errors and warnings in the Event Viewer.
Errors Only, logs errors in the Event Viewer.
Disabled, disables event logs.
The default value is Errors Only.
Allows you to enable the recording of events in the Event Viewer. The
following options are available:
Maximum, logs all information in the Event Viewer.
Warnings Also, logs errors and warnings in the Event Viewer.
Errors Only, logs errors in the Event Viewer.
Disabled, disables event logs.
The default value is Errors Only.
Enterprise Edge 2.0 Programming Operations Guide
Configuring Enterprise Edge Services 209