Dialing Plan Using T1 E&M Lines - Nortel Enterprise Edge 2.0 Programming Manual

In the table, 4 is used as the initial digit for the coordinated dialing plan, but 5, or 6
could also be used for this purpose.
Dialing plan using T1 E&M lines
By properly planning and programming routing tables and destination codes, an
installer can create a dialing plan where T1 E&M lines between Enterprise Edge
systems are available to other systems in the network
Dialing plan for Enterprise Edge network
plan for a network of three Enterprise Edge systems. Each system must be running
Enterprise Edge software. Each system must be equipped with target lines and
Enterprise Edge with an EE-DTM with at least one T1 E&M line. Programming
information for this network is shown in
Dialing plan for Enterprise Edge network
New ork
Network # 2221
Received # 2221
Internal # 2221
Pool H
T1 E&M
P0911588 Issue 01
Tip
When programming a button to dial a Network number automatically
(autodial), network calls must be programmed as external autodial numbers,
even though they resemble internal extension numbers.
Routes generally define the path between the Enterprise Edge system and
another switch in the network, not other individual telephones on that switch.
Enterprise Edge Voice
Pool M
Enterprise Edge 2.0 Programming Operations Guide
Appendix A: Network Examples 337
on page 337 shows a coordinated dialing
Routing information on page 338.
Toronto
Network # 221
Received # 221
Internal # 221
Pool N
Pool B
T1 E&M
Santa Clara
Network # 4221
Received # 4221
Internal # 4221