Isdn Dial Up - Nortel Enterprise Edge 2.0 Programming Manual

Attribute
Static IP Address Pool
Address Mask
4. Press the TAB key to save your settings.

ISDN Dial Up

Enterprise Edge supports ISDN Dial Up for dial-on-demand WAN access. You
have the choice to use ISDN BRI/PRI as your primary WAN connection or as a
back up for your permanent WAN connection.
Creating an ISDN dial up interface
1. Click the Resources key, and then click the Dial Up key to expand the
navigation tree.
The existing ISDN interfaces are listed and the Add button at the top of the
navigation tree is enabled.
2. Click the Add button located over the navigation tree.
The Add ISDN dialog box appears.
3. In the (Dial In) Name box, type the name of the interface you are creating.
4. In the Password box, type a password.
P0911588 Issue 01
Description
Lets you set the IP address Enterprise Edge assigns when a remote site
dials into the Enterprise Edge system.
The default value is 10.10.10.5
Lets you set the IP address mask corresponding to the IP address range.
The IP addresses from the static address pool then reserved for
assignment to remote sites.
The default value is 255.255.255.240
Tips
To use an ISDN dial-up connection, you must first configure your system for
ISDN. For more information, refer to
system is already configured to support ISDN, make sure you configure a Data
Module for ISDN dial up connection. For more information, see
data module .
Tips
After you have created an ISDN dial up interface, you must use
Manager to select which type of network connection the system must use for
primary and backup connection.
Add backup to Name
If you are creating an ISDN interface to use as a backup for a permanent WAN
connection, the (Dial In) Name must contain the string "backup". For
example, "ISDNbackup" is a valid name if you want to use an ISDN
connection as a WAN backup connection.
Enterprise Edge 2.0 Programming Operations Guide
Configuring Enterprise Edge Resources 59
Appendix B: ISDN Overview
. If your
Configuring a
Net Link