242 Configuring Digital Private Network Signalling System1
DPNSS 1 capabilities
A single Enterprise Edge node, acting as a terminating node on the network,
supports the following capabilities over DPNSS 1 lines:
•
Direct Dial Inward (DDI) for incoming calls.
•
Originating Line Identification (OLI) for incoming and outgoing calls:
— For incoming calls, the Calling Line Identification (CLI/CLID) information
is displayed to the user on telephone sets with line display (must be config-
ured in programming).
— For outgoing calls, the directory number of the originating party is sent out
as OLI.
•
Terminal Line Identification (TLI) for incoming and outgoing calls. Referred to
as Called Line Identification.
•
Selective Line Redirect (SLR) and External Call Forward (ECF) implemented
on calls between DPNSS 1, and BRI/PRI, DASS2, and Analog lines.
•
These remote access features are supported on DPNSS: DDI, line pool access
code, destination Codes and remote page feature codes.
•
Software Keys; these are required to enable DPNSS 1.
DPNSS 1 features
The following features are available and can be programmed over DPNSS lines:
•
Three Party Service
•
Diversion
•
Redirection
•
Call Offer
•
Executive Intrusion
•
Route optimization
•
Message waiting indication
•
Loop avoidance
The following parameters can be configured for DPNNS 1 lines:
•
Line Type
•
Prime set
•
CLID set
•
Auto Privacy
•
Answer Mode
•
Auxiliary Ringer
•
Full auto Hold
Enterprise Edge 2.0 Programming Operations Guide
P0911588 Issue 01