Setting Up An Enterprise Edge Ip Address - Nortel Enterprise Edge 2.0 Programming Manual

36 Setting up your Enterprise Edge system
• V.90 modem dial-up username and password (North America only)
• V.90 modem dial-up phone number and optional alternate phone number (North
America only)
The following table describes the Enterprise Edge server connectivity options.
Field Definition
HTTP You can connect to Enterprise Edge from your PC using your JAVA-enabled
Internet browser.
TTY You can connect a dumb terminal to the console of the Enterprise Edge server
through an RS-232 cross-over cable, or you can use Hyperterminal from Win95/
Win NT systems. Refer to the appropriate installation guide for information on
how to use the console menus.

Setting up an Enterprise Edge IP Address

To manage the Enterprise Edge server using a web browser or an RS-232
connection, you must first set up the IP address. The Enterprise Edge server LAN
interface is shipped with default IP address 10.10.10.1 and mask 255.255.255.0.
You can change the Enterprise Edge IP address using
To set up the Enterprise Edge server initial IP address using a RS-232 port:
1. Plug in the Enterprise Edge server.
2. Connect a PC or laptop computer to the Enterprise Edge server RS-232 port
using a null modem cable.
3. Start a HyperTerminal session on the PC or laptop computer.
4. Enter the LAN/WAN IP address and all other required parameters.
To set up the Enterprise Edge server IP address using a LAN:
1. Plug in the Enterprise Edge server.
2. Connect a laptop to the Enterprise Edge server by Ethernet (back-to-back by
using a crossover cable to avoid disturbing the corporate LAN).
3. Set your PC or laptop computer IP address to 10.10.10.2 with a mask
255.255.255.0.
4. Start a web browser on your laptop with a URL of 10.10.10.1.
Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01