General - Nortel Enterprise Edge 2.0 Programming Manual

To copy line settings:
1. Choose Services, Telephony Services, Lines.
2. Click the line (Line 001-364) from which you want to copy settings. If
necessary, choose a subheading to refine your selection.
3. On the Edit menu, click Copy.
4. Click Single or Range from the Copy type list.
5. In the Copy to box, type the line number or the start and end line numbers of
the range of lines where you want to copy the settings.
6. Click the OK button.

General

The General heading allows you to assign the name, a control set, and a remote
package for a line.
1. Choose Services, Telephony Services, Lines.
2. Choose the line number (Line 001- Line 364).
3. Click General.
Name
The default name for a line is "Line" and its three-digit number (for example, Line
001), but you can change it to any combination of letters and numbers to a
maximum length of seven characters.
To change the name of a line:
4. In the Name box, type a name (up to seven characters) and then press Enter.
Control set
The Control set attribute allows you to define a DN that acts as a control set for a
line. By default, DN 221 is the control set for all lines. A control set turns Scheduled
Services on and off for the lines assigned to it. For more information about services,
see Scheduled Services
P0911588 Issue 01
Configuring Enterprise Edge Services 109
on page 138.
Enterprise Edge 2.0 Programming Operations Guide