Link Status; Metrics - Nortel Enterprise Edge 2.0 Programming Manual

5. Select OK to erase all the current statistics and begin collecting statistics
again.

Link Status

When you purchase PRI from your service provider, you can request the number of
B-channels that are allocated for you to use. For example, you may want to use only
12 B-channels instead of 23 B-channels. If this is your situation, you should disable
all the B-channels that you do not need.
It is recommended that the number of lines that are deprovisioned on an EE-DTM
(configured as PRI) be the same as the number of b-channels that are disabled. For
example, If the EE-DTM is on bus 7, when b-channels 13-23 are disabled, you
should deprovision lines 73 to 83.
1. Choose Diagnostics, Trunk Modules.
2. Choose a bus and then choose a module.
3. Choose B channels.
A list of the B channels on this card appears.
4. Click on a channel, for example, B 01
The display shows the status of the PRI channel.
5. On the Configuration menu, click Enable or Disable to change the setting
for the channel.

Metrics

The following usage metrics are available with the Enterprise Edge Software:
• CbC limit metrics
• Hunt Group Metrics
CbC limit metrics
You can view statistical information on call-by-call limit settings for PRI when the
protocol is set to call-by-call routing.
1. Choose Diagnostics, Service Metrics, Telephony Services, CbC limit
metrics.
The display shows the pools that supports CbC routing.
2. Choose a pool. For example, Pool PRI-B
The display shows the services in the pool. The services that appear depend
upon the PRI protocol.
P0911588 Issue 01
on page 301
on page 302
Enterprise Edge 2.0 Programming Operations Guide
Maintenance 301