Adding Or Removing Members From A Group - Nortel Enterprise Edge 2.0 Programming Manual

The operation of some features varies if the Enterprise Edge set is part of a Hunt
group. The table below shows the affected Features.
Feature
Call Forward All Calls
Call Forward No Answer
Call Forward on Busy
Do not Disturb on Busy
Group Pickup
Transfer via Hold
Priority Call
Ring Again
Line Redirection
Page Zones
Voice Call

Adding or removing members from a group

Any Enterprise Edge set, or portable can be a members of a Hunt group. An
Enterprise Edge set can be in more than one Hunt group but is considered a member
in each Hunt group, increasing the total number of members in the system.
There can be only one appearance of the same Hunt group on a set. Hunt group DNs
cannot be members of other Hunt groups. A DN can be associated with a member
of a Hunt group and is called a member DN.
Consult your customer service representative to determine your Hunt group number
range.
To add a member to a Hunt group:
1. Choose Services, Telephony Services
2. Click a Hunt group (Hunt group 1-30).
P0911588 Issue 01
Configuring Enterprise Edge Services 171
Description
The system ignores Call Forward All Calls feature and the
Hunt group call rings at the set.
The system ignores Call Forward No Answer and the
Hunt group call continues to ring until the hunt time
expires.
The system ignores Call Forward on Busy and the Hunt
group call continues to ring until the hunt time expires.
If this feature is active, the set will not receive notification
of incoming Hunt group calls.
If a set is part of a Hunt group and a call pickup group,
then an incoming Hunt group call can be picked up from
any set that is in the call pickup group.
The system support transfer for Hunt group sets; however,
you cannot Transfer via Hold. Once you answer a call on
a Hunt group set, its appearance disappears from all other
sets in the Hunt group so that other calls can come in on
the same line.
You cannot make Priority calls to Hunt group DNs.
You cannot use Ring Again when calling a Hunt group
DN.
The Allow redirect attribute should be set to N for lines
assigned to Hunt groups. For more information, see
Capabilities
on page 98.
You cannot include Hunt group DNs in a Page zone.
Hunt groups cannot accept voice calls. Answer buttons
have no appearances for voice calls, and the set does not
ring.
Hunt groups.
,
Enterprise Edge 2.0 Programming Operations Guide