Requirements - Siemens SIMOTICS CONNECT 400 Operating Instructions Manual

4.3

Requirements

Mobile device for the "SIDRIVE IQ Config" application
To set up the connectivity module, install the "SIDRIVE IQ Config" application on a mobile device.
The mobile device must satisfy the following requirements:
• Android operating system with Version ≥ 8.0 or iOS operating system with Version ≥ 13.0
• Functioning Internet connection
Download the "SIDRIVE IQ Config" application from the Google Play Store (Page 38) or the
Apple AppStore (Page 74).
Mobile device with Bluetooth
The mobile device must have an integrated Bluetooth interface that supports the Bluetooth Low
Energy V4.1 standard - or a later standard.
Wi-Fi connection
The current version of the connectivity module does not support a proxy server configuration.
Use a direct Internet connection.
The connectivity module encrypts your data according to security standard WPA2. For data
transfer, the connectivity module supports Wi-Fi connections with a frequency of 2.4 GHz
and the Wi-Fi standard 802.11b/g/n. Only Wi-Fi passwords with a maximum length of 32
characters are supported.
Note
The SIMOTICS CONNECT 400 connectivity module does not support Wi-Fi authentication
protocols according to IEEE 802.1X.
Ports that are used
Release the following ports used by SIMOTICS CONNECT 400 to allow an Internet connection to
be established:
• Secure data exchange with SIDRIVE IQ Fleet: TCP port 443
• Name resolution via DNS: TCP port 53; UDP port 53
• Time synchronization via NTP: UDP port 123
• IP address assigned via DHCP: TCP port 67, 68; UDP port 67, 68
• The mobile device firmware is updated in the same Wi-Fi network: TCP port 9999
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL
Preparations for use
4.3 Requirements
29