Graco PrecisionSwirl Instructions-Parts List Manual page 79

Swirl Events and Errors
Event Gateway
Code Error No. Event Name
CBR_ --- Swirl Communi-
cation Error
CDR_ --- Duplicate Module Duplicate Swirl Control
EAD_ --- Maintenance
Mode Entered
EBD_ --- Maintenance
Mode Exited
MBD_ --- Maintenance
Due - Orbiter
WBD_ --- Swirl Motor Fault Motor speed is outside
3A2098S
Event
Description Event Type
Swirl Events and Errors
Swirl communication Alarm
error with ADM
Alarm
DGM Detected
Maintenance mode Advisory
entered (self-clear-
ing)
Maintenance mode Advisory
exited (self-clear-
ing)
Maintenance due on Advisory
swirl orbiter
Alarm
the +/- 50% tolerance
range for at least 5 sec-
onds while operating
Cause
The ADM lost commu- Restore communica-
nication with the Swirl tions
Control DGM
Two or more Swirl Verify that all Swirl
Control DGMs have Control DGMs have
the same rotary switch proper rotary switch
setting settings. Reset mod-
ule after changing
rotary switch setting.
Refer to Swirl Control
DGM section, page 22.
Swirl maintenance No action required
mode entered
Swirl maintenance No action required
mode exited
Swirl active time total- Service Component
izer exceeded limit set-
ting If necessary, reset
totalizer
Cable disconnected Verify cable connec-
tions to swirl board,
swirl motor cable, and
swirl orbiter
Shorted motor cable Replace swirl motor
(amber LED on swirl cable (55 ft)
board will be on)
Orbiter bearing failure Replace bearing
Motor defective Replace swirl orbiter
Errors
Solution
79