Setup Mode - Graco PrecisionSwirl Instructions-Parts List Manual

Appendix A - Advanced Display Module (ADM)

Setup Mode

Setup mode screens are divided into five sections:
System setup, Advanced setup, Gateway setup, Fluid
Plate setup, and Swirl setup. While in Run mode, press
to enter Setup mode. Press
navigate through the Setup mode screens.
If the setup screens are password protected, a pass-
word entry screen will appear after pressing
password is defined in the Advanced setup screen. If
the password is set to 0000, the password is disabled.
Advanced Setup Screens
There are four Advanced setup screens, which enable
users to set units, adjust values, set formats, define
USB settings, and view software information for each
component. Press
Advanced setup screens. Once in the desired Advanced
setup screen, press
changes. Press to exit edit mode.
NOTE: Users must be out of edit mode to scroll through
the Advanced setup screens.
Advanced Setup Screen 1
This screen enables users to set the language, date for-
mat, current date and time, password, and number of
minutes before the screen saver comes on. The time
does not automatically update for daylight savings time.
106
to
to scroll through the
to access the fields to make
Advanced Setup Screen 2
This screen enables users to set the units of measure
for maintenance volume, maintenance mass, pressure,
and flow rate.
. The
Advanced Setup Screen 3
This screen enables users to setup USB-related set-
tings. The Disable USB Log Errors option disables
recording events when the logs are at least 90% full.
Advanced Setup Screen 4
This screen displays the software part number and
version for the ADM, USB configuration, Gateway
module, and fluid plates.
3A2098S